Chester - GN Gun Drilled Axles - 31 Spline IMCA / UMP / Wissota / Modified - 27"

Description

GN (Grand National) axles are designed for racecars that run the GN 2-1/2" style rear hubs.  They taper at the end to fit the inner axle tube seal. These are all gun-drilled to reduce rotating weight and polished to a fine finish.
Manufactured out of special aircraft Hy-Tuff steel and precision machined on a CNC. Shot-Peened and Stress Relieved. O.D. Polished to eliminate stress riser lines. Gundrilled axles have axle plugs installed.
• GN axles are used with 2.5" I.D. bearing type hubs (Winters IMCA) or 2.5" type axle tube snouts.
• Axles should be spaced using bolt, lock washer and necessary flat washers to obtain 1/8” - 3/16” of total end play.
The bolt head should be turned to a dull point so only the dead centers touch.
• 24 Spline Drive Plate End
• 31 Spline Differential End ( Most Common )
• Gun-drilled axles have axle plugs installed with a 3/8"  coarse thread for spacing bolt
• Axle Diameter is 1.170" O.D. tapers to 1.375" O.D. drive plate end
• Made in the USA
27" Long End to End