-40%
W1209WK W1209 Digital 12V Thermostat Temperature Controller w/ NTC Sensor Probe
$ 0.52
- Description
- Size Guide
Description
HomeElectronic Component
Chips
Sensor
Arduino Module
Raspberry Pi
W1209WK W1209 Digital 12V Thermostat Temperature Controller w/ NTC Sensor Probe
Popular
Popular
Product Introduction
10K 1% 3950
Probe
1M
Features:
Stainless steel sheath and waterproof
Measurement range: -20 to 105 °C
Length of wire: 1 meter
Size of probe: 5 x 25 mm
Output: 2 wires
Type: NTC 10k±1% 3950
measure environmental temperatures using arduino ADC and this 10k NTC LINK
Resistance to temperature conversion table LINK
B-constant : 3380K -/+ 1%
Typical Dissipation Constant 5mW/ °C
Probe insulation: >100MOhm
Peak Voltage sustain time: 2 seconds, AC1800V 1mA 2 seconds
Stress sustain: 9.8N (1kgF) for 1 minute no deformation
Package Included:
1PC * NTC Thermistor Temperature Sensor Waterproof Probe Cable 1M 10K 1% 3950
W1209WK
Thermostat
Sensor
Controller
Specifications:
Temperature measurement range:-50℃~110℃
Temperature 0.1℃,other paragraph 1℃
Accuracy:0.1℃
Return difference accuracy:0.1℃
Refresh rate:0.5s
High temperature protection:0-110℃
The input voltage:DC12V
Measurement input:NTC (10K 0.5%) waterproof type sensor
Output:10 a relay all the way
Environmental requirements:-10℃,-60℃ humidity 20%-85%
Size:48mm(length) x 29mm(width) x 32mm
Hole size:46 x 26.5mm
Package includes:
1 x Temperature Controller
1 x Temperature Sensor
1 x Instruction Manual
W1209 Thermostat
Controller
With Case
W1209 12V Digital Thermostat -50-110°C Temperature Controller Switch Sensor+Case
Description:
Temperature control range: -50~110°C
Resolution: -9.9~99.9 when 0.1 °C Other temperature range 1 °C
Temperature measurement accuracy: 0.1 °C
Control accuracy: 0.1 °C
Hysteresis accuracy: 0.1 °C
Refresh rate: 0.5 S
Display type: 0.28 inch three digital tube
Input power: DC 12V
Measurement input: NTC (10K 0.5%) Waterproof sensor Line length 300mm
Output: 1 relay output, 5A 250VAC, 20A 16VAC
Environmental requirements: -10~60°C Humidity 20%-85%
Size: 47.5*18.5*31.5mm
Static current: ≤ 10MA, attract current ≤ 65MA
How to use:
Connect the power supply and the load, you can supply to the controller,
Is displayed as a measured temperature,
Press the SET button, the display flashes the temperature,
Press - to set the desired temperature,
After setting press SET to confirm return,
The controller automatically performs the relay by setting off!
Lights, LED status descriptions:
Indicator: Off The relay is switched off, Always indicate the relay is closed.
LED: Shows LL is the sensor open, showing ?HH is out of range, the thermostat will be forced to close the relay, the display --- as high temperature protection.
Package Included:
1PC W1209 12V Digital Thermostat -50-110°C Temperature Controller Switch Sensor+Case
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.